It is no stranger to customized toy bakelite injection molding machines. We can use them to better achieve injection molding effects, and various plastic products in daily life benefit from their functions. Injection molding machine, also known as injection molding machine or injection molding machine. It is an important molding equipment that uses thermosetting plastics or thermosetting plastics to form plastic molds into various shapes of plastic products.
The process of installing molds for injection molding machines is as follows:
1. Installation method for mold positioning ring of high-performance bakelite injection molding machine:
First press the [Eject] button to adjust the device to high, and then press the [Seat Back] button to fully reverse the seat in cylinder.
Place the mold on the lower template, apply the [Adjust] button, press the [Close] button to terminate the upper template at a certain position (15mm up and down) from the mold, readjust the position of the mold positioning ring and the center hole of the upper template, and then press the [Close] button until the upper template is close to the mold.
Turn off the motor, then fix the mold with pins or directly with screws, and the mold installation is completed.
Set parameters such as pressure, rate, position, and time for opening and closing the mold.extrustion blow molding machine.
2. Installation method for injection molding machine without mold positioning ring:precision core parts
First press the [Eject] button to adjust the device to high, and then press the [Seat Back] button to fully reverse the seat in cylinder.
Place the mold on the lower template, apply the [Mold Adjustment] button, and press the [Mold Closing] button to loosen the upper template when it is at a certain position (15mm up and down) away from the mold, thus terminating the mold closing action.plastic spoon machine.
Press the [Seat In] key, release your hand when the material nozzle is about to touch the mold gate, then look from top to bottom, left and right to see if the material nozzle is facing the gate, adjust the mold part to completely match the two. First, press the [Seat Back] button to make the material nozzle avoid the gate, and then apply a thin piece of paper or a bit of ink on the gate. Then, press the [Seat In] button to make the material nozzle touch the mold gate. Finally, take out the paper and observe its imprint or the ink imprint to determine if it is not aligned, Readjust.household plastic mold.
Press the [Seat Back] key to fully reverse the seat. Then press the [Mold Closing] key to make the upper template close to the mold, close the motor, and fix the mold with pins or screws.
Set parameters such as pressure, rate, position, and time for opening and closing the mold.
by eleven