2. The cooling water of the refrigeration cylinder must be turned on;
3. Connect the heating and temperature regulation system;spoon injection machine.
4. Preheat the Gear oil in the high-efficiency thermosetting injection molding machine;
5. The equipment should be started with no pressure in the system to start the pump;
6. Close the protective doors. According to safety regulations, all protective doors of the equipment should be closed during operation. When the protective doors on the operating side are opened, the oil pump will stop running;
7. Adjust all limit switch positions to ensure smooth operation of the moving template;
8. Install the mold
Before using the mold, it is necessary to clean the surface of the mold and the contact surface with the equipment template, check whether the mold's safety is consistent with the safety of the moving template, check whether the ejector rod extends too much into the moving template, and carefully check whether the safety boss of the mold enters the concentric circle of the front template when fixing the template. Then, lock the mold under low pressure and tighten the clamping plate of the fixed mold with screws. All this should be done with the help of a crane or a lifting frame. After the mold is installed, servo type injection molding machine
The stroke roller limits the row sum of the moving template.
9. Adjust the ejection organization so that the thermosetting injection molding machine can achieve the goal of ejecting the product from the cavity.
10. Adjust the mold safety device, and then adjust the travel switch when the mold is closed.
11. Adjust the locking force to the smaller value that can be needed while ensuring the manufacturing quality.
12. Adjust the speed and pressure of the opening and closing mold movement.
13. Check if there are impurities or foreign objects in the silo before feeding according to the production capacity.
14. Adjust the injection seat stroke in the closed mold condition.
15. Adjust the measurement and defense stroke.
16. Adjusting injection pressure and holding pressure (time)
17. Adjust the back pressure, and the nozzle controls the cylinder pressure to its ejection pressure
18. Manually lock and release the mold 1-2 times, and check if the ejector pin and line position are smooth.household plastic mold.
19. Try and adjust the products until they pass the QC inspection. Record all the customized parameters of the thermosetting injection molding machine, and archive and store the the first mock examination products.
20. Adjust the stroke of the robotic arm and automatically reduce the intermittent time to complete the operation.precision core parts
by eleven