1. Check whether the various parts of the second-hand bakelite injection molding machine and the electrical control box are excellent.
2. Check the oil quantity of Gear oil, whether the oil storage is sufficient, and start the motor to check whether the radial plunger valve emits oil normally.
3. Open the cooling water valve and connect the cooling water.
2. Action:
1. Mold installation: Push the moving mold organization to a higher position, install the plastic mold on the moving template, unscrew the fixed template, calibrate the plastic mold lower mold and the fixed template, and tighten the screw. Tighten the plastic mold lower mold to the moving template, operate the moving mold organization, and check if the mold part is correct.servo type injection molding machine.
2. Heating the material barrel: Turn on the electric heating switch of the electrical control box, add plastic to the material barrel, and heat it sufficiently to melt the plastic.
3. The injection operation of the bakelite injection molding machine manufacturer: Connect the solenoid valve 8 to raise the mold moving tissue and close the plastic mold. After connecting the solenoid valve, press the injection plunger into the material barrel for injection molding. After the injection molding is completed, connect the solenoid valve to press the injection plunger out of the material barrel. Connect the solenoid valve 8 to lower the mold moving structure, and then open the plastic mold to release it.
3. Maintenance and upkeep:
1. Check whether the storage condition of Gear oil is sufficient. If it is insufficient, it shall be replenished in time. The oil used shall be kept clean frequently.household plastic mold.
2. The lubrication point should be lubricated with oil on time according to regulations, and the oil filter should be cleaned on time. During the production of the bakelite injection molding machine, maintain cleanliness around the equipment and prevent dirt from entering the fuel tank.
3. After use, the dirt on the equipment should be wiped clean and the smooth surface should be oiled.plastic spoon machine.
4. Regularly inspect the electrical components, remove dirt and oil dust, maintain electrical contact cleaning, and often remove dirt and dust from the connectors.
by eleven